Raise3D Steel Nozzle with WS2 Coating 

Raise3D Steel Nozzle with WS2 Coating 

matching for: Raise3D Pro2, Raise3D Pro2 Plus, Raise3D Pro3, Raise3D E2, Raise3D E2CF 

Characteristics:
 

• Abrasion resistance ​

• ​​High temperature resistance ​

• Lower coefficient of friction than 0.03 with WS2 coating 

• Chemical properties: non-toxic, non-corrosive and insoluble

• Good lubrication and abrasionresistance at the highest temperature up to 450 ° C.

• Very good filament flow

Material characteristics:

• Mohs Hardness: 7.8
• Max. Print Temp: 450°C
• Coefficient of Heat Conductivity: 26W/m.k
• CTE: 12μm/m. °C

The nozzle is not only suitable for normal filaments, but also especially for composite filaments
with abrasive additives such as carbon fiber, steel, wood, boron carbide, tungsten, phosphorescent pigment
etc. and such high temperature resistant filaments.

Instructions:

For Pro2 Series:

Here is the instruction to take out and install the hot ends. Click here.

Here is the instruction to swap nozzle. Click here.

For E2:

Here is the instruction to replace hot end assembly. Click here.

Here is the instruction to swap nozzle. Click here.