Raise3D N series V2H Nozzle

Coated wear-resistant nozzle for Raise3D N series

Raise3D has partnered with Micro-Swiss to provide a coated, wear-resistant nozzle for the Raise3D N-series printer.
Sizes available: 0.2mm / 0.4mm / 0.6mm / 0.8mm / 1.00mm (please select)

Fits for ： Raise3D N series (N1 / N2) Hotend V2

This nozzle is made of a 360 brass base material and has a TwinClad XT coating.
TwinClad XT is a nickel composite coating that is designed for very low friction. It offers one of the lowest coefficients of friction,
better than nickel with PTFE co-coating. This coating is also very hard and abrasion-resistant.
If you work with abrasive carbon fibers, stainless steel, wood-filled or other metal-filled filaments, this will significantly improve the life of your nozzle.

Manufacturer: TwinClad XT
Hardness HVN (as coated): 550-600
Hardness Rc (as coated): 53-55
HVN hardness (heat treated): 825-900
Hardness Rc (heat treated): 65-67
Taber wear index (mg / 1000 cycles, as coated): 42371
Coefficient of friction vs. Steel (dry): 0.08

Extra low friction Is used in injection molding Very good separation properties High hardness (53-55 Rc) Wear resistant Corrosion resistant