LUVOCOM® 3F PAHT 9936 BK
LUVOCOM 3F PAHT 9825 NT is a PA6 filament that is engineered for quality
controlled 3D printing of end-use parts that require strength and toughness in
combination with a high temperature resistance.
FormFutura Luvocom 3F PAHT 9936 BK is an unreinforced and high-temperature
resistant polyamide 6 (PA6) based 3D printer filament that is engineered for industrial applications.
This 3D printing filament features the strength and toughness of pure PA6 nylon without sacrificing any of its printability.
Luvocom 3F PAHT 9936 BK filament exhibits a 50% lower water uptake at a four times slower rate compared to
standard PA6 nylon filaments and is optimized for 3D printing strong parts with a high quality surface appearance.
Luvocom 3F PAHT 9936 BK is temperature-resistant up to 160 °C and has an outstanding mechanical
performance, making it a perfect PA6 filament for 3D printing functional prototypes and
end-use parts with an extremely high dimensional accuracy.
Key features
-
Lehvoss Luvocom 3F PAHT 9936 BK inside
-
Unreinforced PA6 filament with high strength and toughness
-
Temperature resistant up to 160 °C (200h)
-
50% reduced water uptake at a four times slower rate compared to other PA6 filaments
-
Tensile strength up to 78 MPa
-
3D prints with high dimensional accuracy and increased layer adhesion
-
Good electrical properties
Applications
-
Dynamically-stressed parts
-
Functional prototypes
-
Jigs, tools, and fixtures
-
End-use parts
General printing guidelines *
| Nozzle size: ≥ 0.4mm |
Layer height: ≥ 0.10mm |
Experience level: Expert |
| Print temp: ± 255 - 275° C |
Fan speed: 0 - 25% |
Drying: 4h @100°C or 12h @70°C |
| Heat bed: ± 60 - 70° C |
Enclosure needed: No |
Adhesion: EasyFix Nr. VI |
*) Above displayed settings are meant as guidance to find your optimal print settings.
These ranges in settings should work for most printers, but please do feel free to experiment
outside these parameters if you think it is suitable for your printer.
There are a lot of different type of printers, hot-ends and printer offset that it is extremely
difficult to give an overall one-size-fits-all setting.
Filament length
| ρ: 1.25 g/cc |
0.2 Kg spool |
0.5 Kg spool |
|
|
|
| Ø 1.75mm |
± 67m |
± 166m |
|
|
|
| Ø 2.85mm |
± 25m |
± 63m |
|
|
|
Product export information
| HS Code: 39169090 |
Description: Monofilament |
Country of origin: the Netherlands |
Compliance *
This filament is compliant to below-listed directives and regulations.
*) This declaration of conformity to directives and regulations is prepared according to our
present standard of knowledge and may be amended if new cognitions are available and
applies only for the above-described products.
