TreeD Flexmark 7

flexible TPU Filament 1,75mm 500g 70A

The Flexmark range from TreeD combines good printability with high flexibility.
So not only can rubber-like objects be printed, but you can also almost
Use it to create indestructible components.

The lower the specified Shore hardness, the more flexible the material.
However, as the flexibility increases, so does the printability.
Nevertheless, with a little experience, you can still print the Flexmarkt 7 well.

Shore hardness: 70A
Printing temperature: 220 ° C to 245 ° C
Plate temperature: 45 ° C
Board coating: BuildTak, Kapton, Bluetape
Maximum printing speed: up to 20mm / s
Material on roll: 500g
Diameter: 1.75mm

What makes FlexMark the perfect choice for 3D Flexible Printing:

The TPUs are highly resistant to chemical agents, wear-proof and with good elastic comeback.

Mark7 = 70 Shore A, the most flexible, but it requires a perfect calibration of the printer.
Mark8 = 80 Shore A, it is a good mixture of flexibility and stiffness, easier to print too.
Mark9 = 90 Shore A, is the stiffest of all the Flexs, and lets you print as usual.