Fits: Raise 3D N2 / N2 plus / Pro2 / Pro2 Plus 3D printer
With the BuildTak your prints adhere perfectly to the building board. Whether PLA, ABS,
Wood, HIPS, PET + .... With the BuildTak saves you the hassle of printing bed coating with glue,
Blue Tape, Kapton tape, ... Here you have a thin plastic film. This provides perfect adhesion and is
suitable for many printers FFF technology. It is heat-resistant (including usable with a heated plate to
110 degrees) and the chocks are easy to remove after the printing. Still further, the film is very stable
and can therefore be easily reused. Try these new pressure bed coating. You will not regret it.
The film can be cut easily with a household scissors to the required format.
So you have a continuous surface without edges.
Having problems getting your 3D prints to stick? Ready to put away the blue tape, kapton,
hairspray, ABS juice or other solutions? We have the answer! BuildTak is a thin, durable plastic
sheet that adheres to the print bed of FFF (fused filament fabrication) 3D printers. It provides an
optimal printing surface for 3D objects to adhere to for the duration of a print, while allowing for
a clean, easy removal of completed builds.
Instructions
1. Wipe down your bare build platform making sure it is clean and free of debris.
2. Trim the BuildTak sheet to match the size of your build plate (if not already).
3. Remove the white adhesive liner and apply the BuildTak sheet to the bare build plate.
Start from one edge of the build plate and work your way to the other edge, smoothing the
BuildTak sheet with a credit card or decal applicator.
4. Re-level your surface and ensure that the nozzle height is properly set (usually between .10 – .25mm).
Tips:
To ensure the longevity of the BuildTak sheet, use a spatula or putty knife with
smooth/rounded corners. Avoid using solvents, such as acetone, to clean it.
Typically with other build surface solutions, such as blue masking tape or polyimide,
a heavy deposit or “smoosh” is used on the first print layers. With BuildTak this is not needed.
